Fm generation

Post on 17-Feb-2017

301 views 0 download

Transcript of Fm generation

May 1, 2023

1

FM Generation A. D. Patel Institute Of Technology

EC :- Sem V Present By :- Pratik Makadia(130010111017)

May 1, 2023 2

FM SIGNAL GENERATION• They are two basic methods of generating frequency-

Modulated signals

1. Direct Method2. Indirect Method

May 1, 2023 3

DIRECT FM

• In a direct FM system the instantaneous frequency is directly varied with the information signal. To vary the frequency of the carrier is to use an Oscillator whose resonant frequency is determined by components that can be varied. The oscillator frequency is thus changed by the modulating signal amplitude.

May 1, 2023 4

INDIRECT FM2

May 1, 2023 5

FM Generation • FM generation is quite easy. All that is needed is a linear

voltage-to-frequency converter. • If a voltage-controlled capacitor is placed in the feedback

loop of an oscillator and the modulation signal is applied across this capacitor, then the oscillator will change in frequency and the resulting output signal is an FM signal.

• The LM 566C to generate the FM signal.

May 1, 2023 6Fig:- FM generation using the LM 566C. The LM 386

drives the LED

May 1, 2023 7

• The LM 566 is a linear voltage-to-frequency converter which can generate an FM signal up to 1 MHz .

• The LM 566 delivers either an FM square wave or an FM triangular wave.

• The square/triangular wave can be converted into a “good” sine wave with the use of a simple RC filter.

• The input impedance for the modulation signal is 1 MΩ and the output impedance of the square/triangular wave is 50 Ω.

May 1, 2023 8

NOISE IN FM SIGNAL1. Noise is essentially amplitude variations. An FM signal, on

the other hand, has a constant carrier amplitude.2. Because of this, FM receivers contain limiter circuits that

restrict the amplitude of the received signal.3. Any amplitude variations occurring on the FM signal are

effectively clipped off. This does not hurt the information content of the FM signal. Because of the clipping action of the limiter circuits, noise is almost completely eliminated.

May 1, 2023 9